Compatible Systems Octal V.35 - 10/100 RIOP Instruction Manual Page 178
- Page / 381
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
61200780L1-1C © 2004 ADTRAN, Inc. 178
ATLAS 800 Series System Manual Octal FXS Option Module
Test
TX ABCD Forces the Transmit Robbed Bit Signaling (Tx RBS) to a specified value. Values
include
OFF, 0000, 0101, 1010, or 1111.
1kHz Tone Write security: 3; Read security: 5
Sends a 1kHz tone into the following locations, based on test selection: Near
sends the tone out the FXS port, while Far sends the tone into the digital PCM
stream of the ATLAS 800 Series controller. These tests are useful for verifying a
voice path.
Loopback Write security: 3; Read security: 5
Activates loopback tests on a per-port basis.
Calls may be affected when activating the Tx ABCD test. This test is
not valid when the port is used in the
DIAL PLAN.
Option Description
Off
Normal operation.
Analog
Loops the 2W test on itself.
Digital
Loops digital data entering the FXS from the ATLAS controller on itself.
Both
Processes both analog and digital loopback tests.
Loopback tests disrupt the call in progress on the selected FXS port.
Table 5. FXS 2W State Table
Test Tip Output Ring Output
Off No test active No test active
Active Ground Supervision voltage
Tip Open High impedance Supervision voltage
Rev. Battery Supervision voltage Ground
Disabled* High impedance High impedance
Ringing Ringing voltage Ringing voltage
* Disables the output of the FXS port; it does not disable the test.
- ATLAS 800 SERIES 1
- Trademarks 2
- To the Holder of the Manual 2
- About this Manual 2
- Viewing Menu information 2
- Revision History 3
- Conventions 3
- Safety Instructions 4
- FCC-Required Information 5
- Affadavits 7
- Product Warranty 10
- Product Registration 10
- Post-Sales Support 11
- Training 12
- Table of Contents 13
- List of Pinouts 15
- List of Figures 15
- List of Tables 15
- 1. ATLAS 830 DESCRIPTION 16
- Equipment Dimensions 16
- 2. ATLAS 830 FRONT PANEL 16
- ACO Switch 17
- CRAFT Port 17
- Front Panel LEDs 17
- 3. ATLAS 830 REAR PANEL 20
- Admin Port 21
- 10/100BaseT Connection 22
- Alarm Relay Connection 22
- T1/PRI Connections 22
- Engineering Guidelines 24
- Switching Applications 24
- 5. ATLAS 890 DESCRIPTION 26
- 6. ATLAS 890 FRONT PANEL 27
- 7. ATLAS 890 REAR PANEL 31
- Admin In Port 31
- External Input Connection 33
- 9. OPTION MODULE PINOUTS 36
- Quad T1/PRI Option Module 36
- Quad E1/PRA Option Module 37
- Quad Nx 56/64 Option Module 38
- Pin Signal Pin Signal 39
- Quad USSI Option Module 40
- Async-232 Option Module 44
- T3 Option Module 44
- Dual Video Option Module 45
- Pin CCITT Name Description 46
- NxT1 HSSI/V.35 Option Module 48
- Octal FXS Option Module 49
- SECTION 2 SYSTEM DESCRIPTION 50
- System Description 51
- PPP Switching 53
- 3. OPTION MODULES OVERVIEW 53
- 1. INTRODUCTION 58
- 2. TOOLS REQUIRED 58
- Contents of ADTRAN Shipment 58
- 4. GROUNDING INSTRUCTIONS 59
- AC-Powered Systems 60
- DC-Powered Systems 60
- 6. MOUNTING OPTIONS 61
- Option Slots Numbering 62
- 123456789 111213141510 62
- Modules Shipping Contents 63
- Network Turnup Procedures 64
- V.35 interface 64
- Terminal Menu Window 68
- Menu Path 68
- Window Panes 68
- Window Pane Navigation 69
- Right Window Pane Notation 70
- Moving through the Menus 71
- Session Management Keystrokes 71
- Configuration Keystrokes 72
- Getting Help 72
- Security Levels 73
- System Name 74
- System Location 74
- System Contact 74
- Firmware Revision 74
- System Uptime 75
- SYSTEM UTILITY menu 75
- Event Log 76
- Clear System Event Log 77
- Ethernet Port 77
- Craft Port 78
- System Alarms (ATLAS 830) 78
- System Alarms (ATLAS 890) 79
- System Timing Source 79
- Resource Usage 79
- Trunk Usage 81
- Redundancy (ATLAS 890) 82
- Primary Timing Source 83
- Backup Timing Source 83
- ADLP Address 83
- Session Timeout 83
- Max Telnet Sessions 84
- Event Logging 89
- Syslog Setup 89
- Real Time Clock 90
- Access Passwords 90
- Licenses 90
- Bonding Config 91
- Alarm Relay Reset 92
- Alarm Relay State 92
- Alarm Relay Threshold 92
- Ext. Input Alarm (ATLAS 890) 93
- Update Firmware 94
- Update Status 95
- Config Transfer 96
- System Utilization 97
- System Selftest 97
- ASS/FAIL results 98
- ATEL Client 99
- Telnet Client 100
- Client Status 100
- Reboot System 101
- Factory Default System 101
- Alarm Relay Test (ATLAS 890) 101
- 7. MODULES MENU DESCRIPTIONS 102
- Read security: 5 103
- QUAD T1/PRI OPTION MODULE 105
- Alarm Status 106
- DS0 Status 106
- DS0 Alarms 107
- Sig Status 107
- Performance Current 107
- Performance 15Min 108
- Performance 24Hr 108
- Configuration 108
- Quad T1/PRI 111
- QUAD E1/PRA OPTION MODULE 112
- TS0 Alarms 114
- TS0 Status 114
- Sig Status (Port 1-4) 114
- ESULTS field 117
- QUAD NX56/64 OPTION MODULE 118
- DTE Status 119
- Data Rate 120
- Inband Stats 120
- PLL/FIFO 121
- NTERFACE 123
- USSI OPTION MODULE 125
- DTE Interface 133
- OCTAL BRI U OPTION MODULE 134
- Channel Usage 135
- OCTAL BRI S/T OPTION MODULE 137
- T3 OPTION MODULE 140
- DS3 Info 140
- DS3 Alarm Status 141
- DS3 Performance Current 141
- DS3 Performance 15Min 142
- DS3 Performance 24Hr 142
- DS3 Configuration 142
- DS3 Test 143
- DS1 Alarm Status 144
- DS1 DS0 Status 145
- DS1 DS0 Alarm 146
- DS1 Sig Status 146
- DS1 Performance Current 146
- DS1 Performance 15Min 147
- DS1 Performance 24Hr 147
- DS1 Configuration 147
- DS1 Test 148
- T3 Module 149
- T3 D&I OPTION MODULE 150
- Mux Configuration 151
- DS1 Performance 15 Min 158
- T3 (D&I) Module 160
- DUAL VIDEO OPTION MODULE 161
- NXT1 HSSI OPTION MODULE 167
- T1 Enable 167
- T1 Menus 168
- N or OFF 169
- IMUX Menus 170
- HSSI/V.35 Menus 173
- NVERTED. This 174
- Select test by port 175
- None, External DTE 175
- OCTAL FXS OPTION MODULE 176
- FF, ACTIVE, TIP 177
- IAL PLAN 178
- VCOM OPTION MODULE 180
- NABLED; thus, no frame 181
- OICE. For a FAX 182
- OICE displays indicating 182
- VAILABLE 183
- ATLASTotal 184
- ATLASDropped 184
- VCOMTotal 185
- VCOMDropped 185
- Statistics 186
- HDLC RESOURCE MODULE 190
- MODEM-16 RESOURCE MODULE 192
- MODEM-24 RESOURCE MODULE 203
- YSTEM STATUS 204
- ASYNC-232 OPTION MODULE 210
- Signal Status 211
- I/O Status 211
- Session Status 212
- 8. PACKET MANAGER 219
- Packet Endpnts 219
- ACKET ENDPTS/CONFIG menu 222
- Packet Cncts 234
- Cncts Sort 235
- Frame Relay IQ 235
- AX INTERVALS setting 236
- AX DAYS setting 236
- INTERVAL or DAY: 236
- 9. ROUTER (IP) 240
- Static Routes 240
- ARP Cache 241
- Interfaces 243
- UTHENTICATION, opens 244
- ISABLED 245
- ROXY ARP uses the 245
- ORWDATAGRAMS 248
- NERRORS 249
- ICMPOUTERRORS 249
- UDP Relay 251
- NABLE is 252
- PECIFIED 252
- 10. DEDICATED MAPS 253
- Activate Map 253
- Current Map 253
- Create/Edit Maps 254
- EDICATED MAP 259
- DNIS Delay 261
- Off Hook 261
- 11. CIRCUIT STATUS 264
- MAN (Manual Backup) 264
- BKUP Status (Backup Status) 264
- Line Status 265
- EST CALL is configured for 266
- NDPOINT.) 266
- 12. DIAL PLAN 267
- Network Term 268
- ATA 56K 269
- LOT/SVC 270
- RIGINAL# field 271
- User Term 272
- S RECEIVED, effectively 273
- ATA 64K and DATA 56K 273
- Global Param 275
- FCE CONFIG 297
- USSI: User Term - Ifce Config 299
- IST submenus 301
- RIGINATE/ANSWER menu item: 310
- OURCE ID 310
- NABLE SCHEDULE menu item 312
- EST CALL 312
- Introduction 317
- Prerequisite Procedures 317
- Tools and Materials Required 317
- Follow-up Procedures 318
- Login to the System 320
- Setting IP Parameters 322
- Obtain IP Address 325
- Message Description 330
- ADMIN or CRAFT interfaces 333
- Follow-Up Procedures 339
- Instructions for Using Syslog 340
- Review the Syslog Host 341
- Instructions 348
- ASET interface 351
- SECTION 6 SYSTEM EVENT LOG 353
- 1. From the 354
- System Event Log 355
- Untitled Screenshot 355
- 2. VIEWING THE EVENTS 357
- 3. SYSTEM EVENTS 359
- 4. ISDN CAUSE CODES 364
- 5. CAUSE CODE LOG ENTRIES 366
- SECTION 7 ADTRAN UTILITIES 367
- 1. TELNET UTILITY 368
- Session Menu 369
- Edit Menu 370
- Options Menu 370
- Capture Menu 370
- Help Menu 371
- 2. VT100 UTILITY 372
- Port Menu 373
- 3. TFTP SERVER 374
- Server Menu 375
- Print Log 375
- TFTP Server GUI 375
- ADTRAN Utilities Help 376
Related products and manuals for Networking Compatible Systems Octal V.35 - 10/100 RIOP
(4 pages)
(2 pages)© 2020, manymanuals.com. All rights reserved. | 1.542 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals